You are here:
News
News
V8 Firing Orders 2010-12-22
Out of curiosity I have been "collecting" V8 firing orders. So far I have found 5 unique firing orders for a conventional 90 deg bank angle cruciform crank V8.
Fuel injection timing of Common rail engines 2010-12-22
I know how to adjust fuel injection timings of MC engines.
But, In CR(Common rail engine) I don't know how to adjust it.
The only thing that I know is it is controlled by solenoid valve.
Compressor motor keeps burning out 2010-12-22
I have burned out two compressor motors in a very short period of time and want to know if anyone has any ideas on what to check, I would greatly appreciate the help.
Carbon Steel for Instrument Air Pipe 2010-12-22
Is it common to have API 5L B (without galvanised) for the instrument piping material?
MIXING PNEUMATIC AND ELECTRIC INSIDE ENCLOSURE 2010-12-21
Dealing right now with decision of a big control panel for PLC and servo drivers. Almost 50% of space will be available after installing electric control/power components and thinking in using the res
Oil Deaerationv 2010-12-21
I am mostly just looking for some good ideas on how to remove entrained air from oil while filling a bearing assembly.
API 650 Tank NDTS 2010-12-21
Is there any PWHT required or DYE PENETRANT testing and where can i find specs about it??
Pipeline Slug Mitigation 2010-12-20
I have a subsea gas well with reasonable amount of water content. Tieback distance to the host platform is about 5 miles, and it is an 8" pipeline. Initial calculations show that there'll be slugging
